Bosch Benchmark SHX89PW75N Manuel et guide de l'utilisateur Page 19

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 124
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 18
Rinse Aid en-us
19
Setting the amount of rinse
aid used
The amount of rinse aid dispensed
can be set from 0 to 6. Set the
amount of rinse aid to be dispensed
to 5 to obtain a very good drying
result.
You should only change the setting if
streaks remain on the dishes (lower
the amount), or if dishes are not
getting dry enough (increase the
amount).
Set the amount of rinse aid as
follows:
1.
Open the door.
2.
Switch on On/Off button (.
3.
Press Info button 8 for
3 seconds until the following text
is indicated on the display window
at the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
4.
Keep pressing button > )* until
the rinse aid dispenser is
indicated on the display window
at the top @.
5.
Make the selection with setting
buttons + - X.
6.
Press and hold the Info button
8 for 3 seconds.
The chosen setting has now been
stored.
Turning off rinse aid
indicator
Proceed as described in the section
“Setting the amount of rinse aid
used” and set value to 0. The rinse
aid indicator is now turned off.
NOTICE
Using no rinse aid or setting the
dispenser to 0 may result in longer
cycle times consuming more energy
and water. The higher temperatures
and longer cycle times can damage
fine china or glassware.
Vue de la page 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 123 124

Commentaires sur ces manuels

Pas de commentaire